LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Projects Egyptian chair

    I wanted to get a sense of how much labour went into these things, so 95% of the work was done with a hand planes, panel saw, chisels and card scrapers. I used a circular saw to chop up the slabs and a chainsaw to rough out the cherry branch wood I used to make the brace-work. A good percentage...
  2. Custom Walking Cane: African Blackwood, Egyptian Lapis Lazuli Ball, Inlaid Brass Rings

    --------------------------------- This cane has been "SOLD" and resides in Phoenix, Arizona USA To see other walking canes that are for sale, click here - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Just the Facts: Wood: African Blackwood...
  3. The Nile Sofa Table

    The Nile Sofa Table Brazilian Rosewood & Bent Laminated Dyed Ash 52" Wide x 14" Deep x 36" Tall The top is finished with a oil&varnish, and the bottom is finished with black tinted WB poly. I recently finished this piece for my exhibition at the Paradise City Arts Festival over Columbus Day...
  4. Egyptian Style Dresser

    This is oak and walnut. Style was copied from David Marks' show Woodworks on DIY channel. This one was silent auctioned for charity.
  5. It's not my fault! (Geometric Right Angle Guage)

    It's not my fault ;-). Dusty 56 started it. Then Jaykaypur did it. And finally JR45 did it too. I just couldn't help myself … (sob) Really though, I have had a bit to say on Dusty56's and JR45's posts about this guage being based on a theorem of circle geometry (an angle inscribed in a...
  6. Power Tools, Hardware and Accessories
    Hey, I was wondering if anyone knew how to make a "Kirsten Kone," for reverse turning hollow forms? I've been looking online for directions on how to make on but I havent been able to find any good sources. Any help would be greatly appreciated! Here are some images from Jim Syversteins...
  7. Woodworking Skill Share
    Ok, so I recently built a game board which I wanted to place a printed logo (sports team, etc) on the game board and then poly over it. Problem is, as soon as I began to brush on the poly, the paper began to bubble and lift. I then tried to smooth it out and changed to spray poly. Over night...
1-7 of 7 Results
Top