Search Results for ‘drawer slide’

I'm building a coffee table where I want sections of the top to slide out, revealing a hidden compartment underneath. Same idea as this project, but the idea is to have the top in three sections, with the middle fixed in place, and the two ends each sliding out. However, I'm having trouble...

I want to put a drawer on an open wood shelf that has no sides, so I think the best way is to use a pair of bottom mount drawer slides… the kind that attach to the bottom corners of the drawer and are screwed down on the shelf. The drawer will be used for tools, so I guess 75lb or even 100lb...

I am planning to build a jewelry box for my wife with side-mount drawers (so the drawer fronts can be flush with no dividers between them)... I can rount the groove for the slides (See Sketchup picture), and make the wooden strips easily enough, but I have no confidence in my ability to...

I've installed countless drawer slides…but these "Mepla Germany" slides have an interesting bit of hardware on them that I've never seen before. In the pics, shown is an assembled typical CR/DR, but with a bright metal clip that can flip 90 degrees. I'm guessing that the drawer front...

I have all three types of wood that were cut down last summer. The black walnut was 2-3 years old, so is very small in circumfrence. The boxelder was older and blew over in a windstorm. Can't put my arms around the base of the trunk. I have lilac bushes in varying stages of life: new sprouts...

Hi, I'm hoping you can help me find a vertical mount drawer slide that will allow me to lock it at intermittent locations (not just fully extended). The slide doesn't necessarily have to be intended for vertical use - any ideas at all are welcome! It's important that it can be locked at...

I am having an issue with Centerline full extension drawer slides (like Accuride). Older versions of Centerline slides had black rubber stops to keep the drawer closed. They worked fine, but closed a little hard sometimes. The new stops are grey, and close softly. However, they don't keep...

Hi all, I've got my first comission work - a replica Stickley console table which has 2 drawers in the front. The drawers are going to be pretty short - about 4" high. I was contemplating the incorporation wood drawer slides on the drawers but now am not sure whether its worth the hassle or...