LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

21-28 of 28 Results
  1. Coffee Sleeve Dispenser

    My wife and I run a small coffee shop in our church. Since the inception of it, there have been several small projects I knew I would want to build for use in the shop. One of which was this coffee sleeve holder/dispenser. The coffee shop has been open for over 6 months, but I only now have...
  2. M&M/Skittles/Jelly Bean dispenser

    This is a candy dispenser that my dad and I made years ago. It is made out of a 4×4 post of cedar drilled across the side to the other for the ear/candy dispenser to drop into the hole drilled at an extreme angle to meet the cross drilled whole. The ears are circle cut pieces attached to a...
  3. Finishing
    I have a bunch of different liquids in my shop that come in F-style containers like the one in the link below. Does anyone have a good way for dispensing liquids from these containers? I know that pumps exist that could work in these containers. I have containers of Denatured Alcohol, Boiled...
  4. Designing Woodworking Projects
    I have been using 3D CAD for about 15 years because my employer deemed it necessary to be able to communicate ideas in 3D format that was used throughout the company. I did not become a power user by any means because my job was too broad. However, when I needed it was available. I used not...
  5. Woodworking Skill Share
    Any of you guys tried mechanical pencils? I've been looking for a couple of them that are of good quality and I've found that they're either too expensive or just junk. It seems that the only lead size available around my parts is 0.7mm. I'm sure that most of you know that if you're using the...
  6. Power Tools, Hardware and Accessories
    This is not a HF bash. I buy things there all the time and I'm not going into the pros and cons of their tools. Like many, we all get HF sales flyers in the mail on a routine basis. Some toss them, but I keep them up until the time their sale expires; then I use them to start my barbecue. The...
    tip
  7. Power Tools, Hardware and Accessories
    Hello. Digging for expert opinions… I've been using a homemade router table for several months, but it has proven to be a total failure. :( Now I really need a new one, and I don't want to mess around. I'm ready to buy a high-quality table and lift. I don't want to spend more than ~$800. Here's...
21-28 of 28 Results
Top