LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. Corner Table

    I made this corner table to hold my stereo and some woodworking books on the second floor of my work shop. I have two more speakers on the first floor that are wired into this system. The stereo holds five CDs, so I can work for a long time without needing to change the music. I also built...
  2. Hand Joinery Bedside Table

    Quarter-sawn Mahogany, 2010 "Hand Joinery Bedside Table" was my first project completed at Rochester Institute of Technology. The requirements for this piece was to use all hand tools to make a small table, using only the bandsaw to rough out general shapes, every finished surface and all...
  3. Corner Table

    I made this table for an entrance to my house. A perfect place to set keys, coffey, mail, etc. I have made multiple versions of this table featuring different edges, wood species, leg heights and even a 3 tier version. There really isn't much to this piece. I used tight fitting dowels to...
  4. corner lamp table

    Hi all, It's been a while since I last visited or posted anything but I have been very busy setting up my very own woodworking business. Here is a table I made for a client. They wanted it for a corner that sits empty in their hall way. They wished for a lamp to brighten up the space. I...
  5. Corner Table

    This was my second project when I was a complete beginner. I needed a corner shelf or corner table to drop my keys outside of my garage door and I couldn't find anything in a store. This was a very utilitarian project but I still had fun building.
  6. TV Table

    This project was my first venture into using a tortion box technique. It turned out nicely but it was a real learning process. I went with the tortion box design for a couple of reasons. 1) I wanted to keep the weight down and 2) I wanted to create internal channels to run all of the wires. I...
  7. Placeholder :-)

    So… I've got a spot at the corner of my two sofas that needs a table. Trouble is that I have three or four projects lined up in advance of that table (and I haven't yet come up with a design idea I like). SO… I banged this puppy out in a few hours just to function until I do something for...
  8. Corner table in Purpleheart and Maple

    Here is a corner table I made for a friends office. I features Purpleheart whith a laminated front apron. The legs were hand sculpted. I has maple inlays and shellac finish.
  9. Craftsman Corner Table

    This is one of my "therapy" projects I made when I first started making A & C furniture. The entire piece is made with hand tools. Fine woodworking (#173) posted my jig for holding the legs at an angle, in order to chop the mortises straight, several years ago. The table is made from quarter...
  10. Pedestal Table (prototype)

    Didn't know how this was going to look as a corner piece for our living room, so I first made it of pine scraps that I had around the shop. The final will be made from walnut with laminated distressed copper panels on all 4 sides (if I can figure out the best way to permanently laminate the...
  11. Off Topic Coffee Lounge
    You've worked Very Hard to get where you are…. Years of training to get to this Level…. You're Competeting against the BEST there is. ....There is NO margin for error! It's the Ladies 600 Metre Race. The Entire Race takes about One and a Half Minutes. THEN…...At 58 Seconds the Worst Thing You...
1-11 of 11 Results
Top