LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Flush trim saw

    I needed a flush trim saw for my dowels. 1. I cut of a piece of the saw from a hand miter saw. 2. A piece of aok and shaped it. 3. Drill holes in the saw and attach it to the piece of oak. 4. The saw in use. It works pretty well. 5. And the results. Houtje
  2. Snake spoon

    All hand carved. Haven't a clue what type of wood it's made from. Found a flat board in a shed at home. Lo & behold - one afternoon of carving outside in the Autumn sunshine later = one snake spoon. Beats pulling weeds, that's for sure.
  3. Power Tools, Hardware and Accessories
    About a year ago i stumbled across a gentleman that was getting out of woodworking. Got some great deals one of which was his Ridgid 6 1/8" jointer(model before the current orange one). Being new to woodworking myself I went about trying to joint some lumber and was effectivly making tapered...
  4. Power Tools, Hardware and Accessories
    Hi, So I purchased a used Minimax Fs35. The tables are flat when measured against themselves but are not coplaner. Unfortunately, I only have experience with adjusting parallelogram beds and am not sure how to adjust these. I assume there will be shimming involved, but I'm not sure how to...
  5. Power Tools, Hardware and Accessories
    The wheels on my saw aren't coplaner, with the bottom one shy by about 3/8". I've removed the nut and washer and am guessing it just takes elbow grease to pull the wheel off the hub. So…a couple of questions. 1. Am I right that it takes a little effort to pull the wheel? I don't want to screw...
  6. Power Tools, Hardware and Accessories
    Hello, I recently bought and set up a new Powermatic 6" jointer. I attempted to set the jointer up following the instructions on wood whisperer (using a 50" straightedge and feeler gauges to check for coplanarity) and I found that the infeed table is about .010" lower at the cutter head than it...
1-6 of 6 Results