LumberJocks

stanley2's Blog

  • Advertise with us
This blog is written by stanley2 | 3 entries so far

Latest Entry

Router Lift #1: Router Lift

07-27-2019 03:49 PM by stanley2 | 1 comment »

DIY Router Lift Trying to adjust bit height from underneath the table is a hassle which gave rise to several after market router lifts and diy lift plans. I have a 3-1/4hp Freud plunge router mounted under my Incra table. There was no way I would spend the money asked for a router lift. Here’s what I did to adjust the router from above the table. All for the cost of a couple of nuts and some time. 1. Separated the router motor from the base.2. Removed the pin locking the adjustment screw to the base.3. Threaded that end for a 3/8’ nut.4. Used super glue to fix the nut in place.5. Drilled a hole through the nut and pinned the nut to the adjustment screw.6. Used ...

Read this entry »

Older Entries


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com