LumberJocks Woodworking Forum banner

Looking for a SAFE way to rip thin strips on a Radial Arm Saw

3K views 10 replies 10 participants last post by  DBC 
#1 · (Edited by Moderator)
The title kind of sums it up. I've got an old Craftsman RA saw that's in very good shape and is my primary power saw, (I'm mostly a hand tool guy).

I'm making several utility cabinets from birch plywood and I'd like to edge band all of the exposed edges for durability.

Does anyone have a safe solution to rip 1/4 X 3/4" thin strips?

Thanks for your help everyone,

I like this forum.

parkerdude
 
#5 ·
Parkerdude,

The problem with using the RAS for this type of cut is the usable bit ends up between the blade and the fence or you spend a lot of time relocating the trolly. The easiest way to do this on a RAS, to quote 'mater from CARS is "to not to". ;)

Where are you located? Maybe there's a 'jock near you with a table saw.

Whit
 
#6 ·
I'm not very smart. I have tried to rip on my RAS.
Twice I got hit with kickback.
Both did damage to things in the shop, both knocked me on my ass and left me bruised.
There is NO safe way to rip on a RAS. There is just luck.
I no longer have a RAS.

Lee
 
#7 ·
First you will need a blade meant for the RAS. Second you will need a few holddowns. Once the holdowns are set up so the blade does not grab and lift the wood you can slowly feed it thru with a long scrap block. I feed mine from the left side of the machine.
 
#9 · (Edited by Moderator)
Just two days ago I was giving a Sears 10" radial arm saw. In Excellant shape. A friend gave it to him. He has had a high end cabinet shop for at least 25+ years.

He has one in his shop already.

His words were this saw is free to you if "YOU LOCK IT AT 90 or 45 DEGRESS AND DON'T USE IT ANY OTHER WAY NO MATER WHAT ANY BOOK SAY'S TO USE IT ANY OTHER WAY" Every piece of equipment has its purpose and that is the purpose for that saw. A long stroke cut off. Period.

I have not used it yet but thought I would pass on the advise I was given.

LOL, Dino
 
#11 ·
Marcb:

I believe you are correct !

My advisor new I do not have experience with a RAS and was only thinking of my safety with a tool that can cause great person harm. As can most of the tools of this Hobby/Profession.

I apologize to all if I spoke out of line,

Dino
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top