| View skess's: | home | workshop | projects (0) | blog (0) | reviews (0) | forum topics (3) | buddies (0) | favorites (0) | activity log |  |
| 02-02-2022 05:44 PM |
Thin Kerf Blades - 18 replies I’ve been trying to setup my miter gauge on my table saw. The blade I was using was that Freud 24 tooth ultra thin kerf framing blade. After a lot of back and forth adjusting, I have come to an understanding that this blade might not be very good for miter cuts. It was consistently giving me horrible cuts – not square and with a ... |
| 01-18-2022 08:36 PM |
Riving Knife (aftermarket) - for old Delta 34-600 - 2 replies Hi guys,I posted about the bearings on my 34-600 in another topic. I figured I would make a separate thread here since this is a safety concern. I’m new to table saws and I’ve been reading that you should use a riving knife or a splitter to help prevent kick back. Well, this saw didn’t come with one. I was thinking if pur... |
| 01-18-2022 10:53 AM |
Delta/Rockwell Table Saw Arbor Bearings - 11 replies Hi,I just inherited a Delta 34-600 table saw from my uncle. It runs. But, it is old. So, I was thinking of replacing the bearings on both the motor and the arbor if necessary. I’m going to definitely change out the motor bearings. But, I’m not certain on the arbor bearings. I was hoping you guys could guide me as to whether or ... |
