LumberJocks Woodworking Forum banner

Project Information

Hey guys,

I wanted my logo for my shop/website/channel to be something physical tangible while at the same time trying something fun. I used Ridgid's new trim router and one of the weed burner/baby flamethrowers to free hand carve a few signs out a walnut crotch and a maple burl I had laying around.

First I printed a template and attached it to my stock and then very carefully tracked the lines working from inside out of each of the letters.

After the logos were carved out I did two different types of "pyrography" on one I put a little bit of char to accent the white lettering, on the YouTube logo I did all the coloration with the char ala Shou Sugi Ban.

I love the way these turned out, I did a video on this on my channel, check it out below.

Please like, share, and subscribe.

View on YouTube

Thanks for watching,

Rick
Wood.Work.LIFE


Gallery

Comments

· Registered
Joined
·
584 Posts
AS a formerly licensed full scale pyromaniac like you; I love them. ( I was a licensed boiler operator and a certified volunteer fireman for several years-both classified as full scale pyros!)
 

· Registered
Joined
·
63 Posts
AS a formerly licensed full scale pyromaniac like you; I love them. ( I was a licensed boiler operator and a certified volunteer fireman for several years-both classified as full scale pyros!)

- ralbuck
LOL, I don't think I licensed, but damn is it fun.
 

· Registered
Joined
·
34 Posts
Always fun when fire is involved.
 

· Registered
Joined
·
63 Posts
You know it!
 
Top