LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.

Project Information

I made a tapering jig to use during an Adirondack chair project. Not shown is the 36" Rockler miter bar for the runner. It's roughly 32" long and 13" wide. It will be trimmed in width by about an inch more when I slide it past the blade for the first time using the miter track and bar. I hope to get a lot of use out of it in the future.

Gallery

Comments

·
Registered
Joined
·
28,289 Posts
Nice handy jig…Cheers, Jim
 

·
Registered
Joined
·
258 Posts
Nice. I made one very similar. I left off the miter bar, since I rarely needed the capacity. Just set my fence for 12 inches and run it through.Has worked great for many years. Yours is much prettier by the way.
 

·
Registered
Joined
·
558 Posts
You've made a nice handy jig. Tapering jig is one of my most used home made jigs
 

·
Registered
Joined
·
20 Posts
Nice. I made one very similar. I left off the miter bar, since I rarely needed the capacity. Just set my fence for 12 inches and run it through.Has worked great for many years. Yours is much prettier by the way.

- tt1106
Thanks Todd… I read the Rockler manual for theirs, which I copied, and they tell you to use the jig without the miter bar as a straight line rip guide using the fence like you do. So I've got that going for me which is nice… Carl Spackler
 
Top