LumberJocks Woodworking Forum banner

Project Information

This coffee table was made from a couple pallets I found. Usually there are gaps on pallets but I lucked out and found a couple that had no gaps for the most part except on the ends, no problem just took the skilsaw and cut those parts off. Then I trimmed out the sides with Douglas Fir 2×6 for the top, ripped another 2×6 with the skilsaw to fit the bottom trim. I cut a 4×4 to act as legs in connecting the top boards to the bottom boards. Stained with Miniwax Ipswich Pine and finished with satin polyurethane.

Gallery

Comments

· Registered
Joined
·
4,507 Posts
Very sturdy table, Joel!!

Jim
 
Top