LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.

Project Information

This is an end table I built as a Christmas present from quartersawn white oak. It is finished with tung oil wiping varnish.

This table was one of the first projects I built so I had a very limited selection of tools. This was done using basically just a table saw and a router table. I had just bought a raised panel router bit set and used it to make the sides of this table. I made a long sliding dovetail slot in each of the 4 corner legs of the table and made the mating dovetail along the length of each raised panel side. After apply glue I slid all the panels into the legs and clamped it up to dry. After it dried I routed a 3/4" rabbet into the bottom and glued in the white oak plywood floor of the cabinet. The top is attached with figure 8 table top fasteners. I used European style cup hinges for the door and slides for the drawer.

Gallery

Comments

·
Registered
Joined
·
2,983 Posts
Wow! Very nice work. I like this a lot.
 

·
Registered
Joined
·
867 Posts
came up on the front page. Very cool work!!
 
Top