LumberJocks Woodworking Forum banner

Project Information

Hi LJ's. This is recently completed sink stand with an edge grain counter top. Pretty straight forward build. It's constructed from 8/4 Hard Maple with loose tennon joinery. Lots of big lumber on this project. The legs are 3×3 inches square and the top is 1.5 inches thick. The top was glued up in seven different sections. The base was assembled on site (a relative's new home in Colorado) and the top was trimmed to fit a specific space in the laundry room. The finish is two coats of Minwax Polycrylic. It's mostly used as a bath for the family dog. Happy to answer any questions. Suggestions, as always, are welcome. Thanks LJ's…

Gallery

Comments

· Registered
Joined
·
3,876 Posts
Very Nice Piece Of Work & Well Done Tim.
 

· Registered
Joined
·
11 Posts
Thanks Rick. I appreciate you taking the time to view and reply to my project…
 

· Registered
Joined
·
10 Posts
That looks very nice. I think that's the same sink I put in my kitchen a few months ago, but I went with stained pine.
 

· Registered
Joined
·
11 Posts
Thanks morath. Yeah, that sink is a monster. Very heavy. I was always worried about dropping the darn thing during the build process…
 
Top