LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.

Project Information

This is the second live edge charcuterie board that I made. I used my Shaper Origin to engrave the "A" and my router table to create the undercut finger grip areas on the left and right sides. Of course I added my "Handcrafted…" brand on the bottom. After sanding to 400, I applied four coats of cutting board oil, followed by two coats of cutting board conditioner, followed by buffing.

Gallery

Comments

·
Registered
Joined
·
3,743 Posts
Is it walnut? Beautiful grain.
 

·
Registered
Joined
·
8,109 Posts
Very attractive. I wasn't aware a shaperOrigin could do such small work. Good to know.
 
Top