LumberJocks Woodworking Forum banner

Project Information

Ok, so I had an old kitchen table made from rubberwood strips and I moved house, I had to cut the table down to fit in the new place and was left with some rubberwood. I also had a few strips of wenge left over from a previous project (man that stuff is hard to work!!!) and so I set to work gluing it together and had some fun coming up with a kinda pattern.
Glued it all up and got to work with a low angle block plane, sanded and finished it with sunflower oil.
It now resides in my partners kitchen, except she likes it so much, she wont use it.
Go figure!

Gallery

Comments

· Registered
Joined
·
7,151 Posts
Well done and welcome to the club!
 

· Registered
Joined
·
17 Posts
Nicely done!! Tell her to just cut on one side and display the other side, unless of course she is as oooo good, she is able to cut on both sides at the same time.
 

· Registered
Joined
·
259 Posts
Looks great, like the cool pattern and very nice contrast of wood colors. Great job!
 
Top