Project Information
Hi all,
Been awhile since I have posted anything, but just finished one of the largest pieces that I have built. This is an executive desk for my home office. Overall dimensions are 66" wide, 34" deep and 31" tall. It Breaks down into 4 major pieces. The top, the 2 banks of drawers and the middle panel that joins the 2 banks of drawers.
Constructed from SYP 2×12s from HD, the legs are 2"x2" with a cove cut on outside corners for visual interest and a 1/8" round over. All other pieces are 7/8" with the same round over. The bottom stretchers all have a curve that was drawn with a shop made drawing bow and cut on the bandsaw. I faired the curves with a spokeshave and sanding. The carcasses are assembled with mortise and tenon joinery. I got lazy on the drawers, and I assembled them with 1/2" ply and butt joints screwed together. The drawer fronts are 7/8" with a 1/2" round over and a rabbetted bottom.
The carcasses have 3/8" panels that are are set into frames. All drawer slides are wooden and shop made. I sanded everything to 220 and stained with Minwax Red Oak. The finish is Minwax Satin poly. Mixed 1/2 & 1/2 with mineral spirits. Wiped on with t-shirt scraps. 5 coats with a light 0000 steel wool sanding between each.
I have a lot of pics. I am going to add them below.
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
Thanks for looking!
Been awhile since I have posted anything, but just finished one of the largest pieces that I have built. This is an executive desk for my home office. Overall dimensions are 66" wide, 34" deep and 31" tall. It Breaks down into 4 major pieces. The top, the 2 banks of drawers and the middle panel that joins the 2 banks of drawers.
Constructed from SYP 2×12s from HD, the legs are 2"x2" with a cove cut on outside corners for visual interest and a 1/8" round over. All other pieces are 7/8" with the same round over. The bottom stretchers all have a curve that was drawn with a shop made drawing bow and cut on the bandsaw. I faired the curves with a spokeshave and sanding. The carcasses are assembled with mortise and tenon joinery. I got lazy on the drawers, and I assembled them with 1/2" ply and butt joints screwed together. The drawer fronts are 7/8" with a 1/2" round over and a rabbetted bottom.
The carcasses have 3/8" panels that are are set into frames. All drawer slides are wooden and shop made. I sanded everything to 220 and stained with Minwax Red Oak. The finish is Minwax Satin poly. Mixed 1/2 & 1/2 with mineral spirits. Wiped on with t-shirt scraps. 5 coats with a light 0000 steel wool sanding between each.
I have a lot of pics. I am going to add them below.
Thanks for looking!
Continue with Google
