Here in West Texas crosses are very popular for people to collect and display in their homes. I have made twenty of them and have sold two already. I plan to sell them at some local festivals and street fairs. One of these is made of mahogany and the rest of cedar , all with maple inlays. 18" Tall and 3/8" thick. The way I make them is: after re-sawing to 3/8" and sanding smooth I cut the wood to 3 1/2" wide by 18" and 12", place them one over the other and hot glue them in place, front and back. I then cut this unit diagonally through there center on my miter saw. Then make two cuts on the halves to make four pieces. Remove the scrap and glue the four pieces together and hold in place with masking tape. (kinda hard to clamp) After glue sets up I like to put the inlay at the intersection and cut a slight taper on the four pieces tapering smaller toward the intersection. The inlay helps hold this otherwise weak end grain joint together. When I put the inlay near the bottom I do the inlay before assembly. On those I glue a 1/8" doubler to the back at the intersection. I use the double bevel inlay method which only involves a scroll saw and glue.