Project Information
This is my latest project for my workshop. The design is based off project by LJ HickoryHill found here. The design of the drill shelf was based on ShopNotes Issue 58 along with the design of the drawer.
The case is made out of 3/4" plywood. The drawer is made out of 1/2" plywood with a 1/4" plywood bottom. The handle is made from walnut. The top shelf is hinged to allow for access to the power strip. The cabinet is attached to the wall via a French cleat.
The pictures are as follows:
- Pictures 1 & 2: Overall Cabinet
- Picture 3: Accessory Drawer
- Picture 4: Walnut Handle
- Picture 5: Hidden Power Strip to feed the chargers
- Picture 6: Gluing up the case; you can never have enough clamps!!
Thanks for reading.
The case is made out of 3/4" plywood. The drawer is made out of 1/2" plywood with a 1/4" plywood bottom. The handle is made from walnut. The top shelf is hinged to allow for access to the power strip. The cabinet is attached to the wall via a French cleat.
The pictures are as follows:
- Pictures 1 & 2: Overall Cabinet
- Picture 3: Accessory Drawer
- Picture 4: Walnut Handle
- Picture 5: Hidden Power Strip to feed the chargers
- Picture 6: Gluing up the case; you can never have enough clamps!!
Thanks for reading.
Continue with Google
