LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.

Project Information

Been wanting to build both a new router table and a face frame clamping table. Came up with the idea of combining the two but not being sure how I will like it I decided to use my old out feed table & cabinet as a trial run. If I like the table then I will build a nice cabinet under the table. Over the next few months I will be building a complete kitchen for my mother-in-law, I figure that should be a petty good test run. The lift is the PLR2 fitted with a Milwaukee 3 1/2 router. the fence is an Incra 32" ultra positioner I had laying around fitted with an Incra wonder fence. The blue is the Kreg Klamp Trak while the red is purple heart I shaped like the Klamp Trak simply to be a place holder until I decide if I like this design enough to purchase a couple more sections of Klamp Trak.

Gallery

Comments

·
Registered
Joined
·
19,680 Posts
Thats an amazing table Ken
 

·
Registered
Joined
·
810 Posts
That thing is gorgeous.
 

·
Registered
Joined
·
268 Posts
This is beautifull. Let us know how it works for you. Very nice and good luck with all the cabinets.
 

·
Registered
Joined
·
49 Posts
Very nice multifunction table you are planning there..

Thanks for sharing
 

·
Registered
Joined
·
1,266 Posts
Ken looks great and I know it going to be a joy to use, just received my LSSSys. yesterday. I sold my Ultra of 20 years, what a great piece of equipment. I would love to have the same set up but not enough room right of the TS. Thank for posting and stay safe…BC
 

·
Registered
Joined
·
5,163 Posts
Now that is a nice addition to your shop. Great idea on combining the two into one table.
 

·
Registered
Joined
·
103 Posts
Great table Ken. Thanks for sharing. Keep us updated on the Kitchen build.
 

·
Registered
Joined
·
201 Posts
That's a great table. Very useful.
 

·
Banned
Joined
·
2,577 Posts
Your table is a great looking and functional design Ken. Let the fun begin… It looks like you are mounting your positioner bracket on a board on adjustable tracks. Is that done so you can remove it when using the table for face frame clamping with the Kreg clamps? Good idea.
It must be nice to have an Incra 32" ultra positioner laying around. I bought the LS system back in December and it is great. Definitely takes up a lot os space but worth it.
 

·
Registered
Joined
·
1,466 Posts
GREAT idea! Well done too.
 
Top