LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
Showcase cover image for Coins Box

Comments

·
Registered
Joined
·
14,504 Posts
I am almost definite to buy TS2500ci Scheppach Table Saw.
The cast iron table bed/table top is not "mirror finished" ground as found in most table saws in the market (so far as I'd seen in the advertisement).
Does it really matters?
Your comment please.
 

·
Registered
Joined
·
1,939 Posts
1st: Is the table ground flat within a couple of thousandth's across the surface? Is so then you good.

2nd: If the non-mirror finish to the top does not cause a extra friction as a piece of lumber slides across the top I still don't see an issue.

Looks like it has a sliding table and dust collection built into the guard; also Very nice to have.
 

·
Registered
Joined
·
2,157 Posts
I do not know this saw. What you look for is smooth and friction free. Also a surface that will remain as it starts with little or no maintenance. A painted surface would be great if the paint didnt eventually come off.. It is about low friction and long wear.

Can you see one in person to test it out?

When I purchased my saw and jointer from Grizzly years ago, I asked for references in my area then called them to get the low down. I found a guy 10 miles from home and went to his shop to check both out. Not only did I get to see one up close and hear from a guy who uses his daily, I made a new friend.

If the company has no references, I would be weary.
 

·
Registered
Joined
·
1,225 Posts
I think this should have been posted in one of the forums or something. Maybe a blog to follow the process of picking out a saw and setting it up, etc. Nevertheless, I wish you luck and a friction free future.
 

·
Registered
Joined
·
11,989 Posts
"Attached picture for members to review"
Picture is too small and out of focus to really " review" anything about the saw….This really isn't a project and probably should be posted in the forums section . Have a great day : )
 

·
Registered
Joined
·
11,989 Posts
well I like this box much better than the saw picture you had posted here earlier : ) Any more shots of the box to post ?
 

·
Registered
Joined
·
1,930 Posts
Great job!

Thanks for the post

Callum
 

·
Registered
Joined
·
14,504 Posts
Tank you Jeanmarc, Beginningwoodworker and everyone for viewing this post and your kind words.
Take care and work safe.
 

·
Registered
Joined
·
4 Posts
A beautiful specimen. I particularly like the foot detail.
 

·
Registered
Joined
·
14,504 Posts
Thanks Woodhawk for the compliments!
 

·
Registered
Joined
·
14,504 Posts
Thank you Smile,
......as always you like to make other people smile.

Have a good night…
 

·
Registered
Joined
·
51,858 Posts
Great looking coin box. Excellent job! The color is gorgeous.
 

·
Registered
Joined
·
14,504 Posts
Thanks Wayne, for the kind words.
 

·
Registered
Joined
·
866 Posts
Very nice box Woodworm.
 

·
Registered
Joined
·
72 Posts
Thanks for the big hello woodworm. I'm liking your boxes here…nice job.
 

·
Registered
Joined
·
245 Posts
I was looking at the projects you posted. Earlier you had one regarding failed miter joints. The pieces look like the sides of this box. What did you finally use to secure your miter corners, if this is the same box.
 
Top