Project Information
So for Father's Day I got an awesome gift of a little Bluetooth speaker and I decided that when I'm out in the deck a little stand would be awesome ..
I had some scrap 4×4 and I decided to use that, I put two channels (1" wide and 1/2" wide on opposite sides of the 15" piece of wood, using my router and a 1/2" straight bit
The left hand Chanel is 7" x 1"x 1/2" and this will house the speaker and the right hand chanel is 5" long x 1/2" wide x 1"deep and this will fit the iPhone …
On the the front face I used my 2" Forster bit in my drill press to give the impression of speakers and basically sanded it and stained it..
I think it came out good…
I had some scrap 4×4 and I decided to use that, I put two channels (1" wide and 1/2" wide on opposite sides of the 15" piece of wood, using my router and a 1/2" straight bit
The left hand Chanel is 7" x 1"x 1/2" and this will house the speaker and the right hand chanel is 5" long x 1/2" wide x 1"deep and this will fit the iPhone …
On the the front face I used my 2" Forster bit in my drill press to give the impression of speakers and basically sanded it and stained it..
I think it came out good…
