LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.

Project Information

A couple weeks ago my mother and father showed me a photo of something like this on facebook stating they would like something like this. A friend of mine who I have known my whole life who is like an older sister stated she would like to have something like this as well. Well I notice the other day that her birthday is coming up and this will be a gift to her from me and my wife.

To make the cuts, instead of measuring and marking each one I took a piece of scrap, the same width of the cedar and made it to act as a template. These pics are for a 6" clay pot and to make the marks on the template I laid the wood on my table and put the pot on it's side. I then makedthe top and bottom of the pot with a speed square on the cedar. Now I wanted the angle (the portion that runs along the side of the pot) to end at the bottom of the pot and so after ligning this up I marked the side of the top rim of the pot. In the end the lines on the cedar looked like the side of the clay pot - Ref to the 3rd pic.

I put some double sided carpet tape on the template and put it where you see the marks on the 3rd photo. I then set up my fence on the drill press to keep all of the holes at the same distance from the side and put a sacraficial board on the back side of the cedar to prevent or lessen any damage. I used a forstner bit and only allowed the center portion to punch through the other side. I then flipped the board to finish the drilling.

I then moved the board to my scroll saw to make the cuts. Now I found out on my last board that my dremel with a round sanding bit was the same size as the hole and this allowed me to smooth out the cuts.

I didn't take a pic of it but I did use a 1/4" roundove bit on my router to round all of the edges to give it a more pleasing look. I then used my rotary sander to smooth it all out and remove any or most of the burn marks. Then it went to sanding by hand in the small spaces.

I know the making of my templates sounds a little crude but the template is easier to make than it sounds.

The question I have is how much should I sale something like this for? This is because I have gotten several requests and I am not sure if I should say 30, 40 or more (or less)

Gallery

Comments

·
Registered
Joined
·
5,687 Posts
A novel idea, thanks for posting this.
 

·
Registered
Joined
·
1,442 Posts
Cool idea! I have a neighbor who would love this on here deck.
 

·
Registered
Joined
·
121 Posts
Very nice. I was looking at Pinterest and saw one that had the pots attacked to a post. This would be great for growing herbs for the kitchen. Thanks for sharing.
 

·
Registered
Joined
·
17,398 Posts
Great idea,just what I need.
 
Top