LumberJocks

WBBN's Bench Top

  • Advertise with us
Blog series by robscastle updated 11-28-2020 05:00 AM 4 parts 1919 reads 40 comments total

Part 1: Starting Bench Top Part 1

10-22-2020 02:24 AM by robscastle | 4 comments »

arrrg WBBN and his finishing Bench! I was going to have the day off too! Well I guess I needed to upgrade anyway. Even LBD suggested it was a Festool Look alike, but I think he may have been trying to take the Micky actually So I set to work. Had a few pallet bit left over from my Smiths Chips days when I actually got paid for doing wood work. these are 1100×150 x 25 mm Hardwood planks of some species, possibly Yellow stringy bark not really sure. Cut them i...

Read this entry »


Part 2: Starting the bench top part 2

11-25-2020 11:05 PM by robscastle | 6 comments »

Well its November and I am back home once again.Partly being able to stay at anthm27’s instead of 14 days in a motel (on my own)Anyway I got a lot done between the heat, had to put up a shelter to be able to work. Did a bit of research on half lap joints for the edging. Found these Jigs. Originally designed for a router but with a bit of modification I could use them with a table saw I made the stile jig first as it looked the most complicated. the chunk of timbe...

Read this entry »


Part 3: Out of the clamps and Raw finishing

11-27-2020 02:54 PM by robscastle | 3 comments »

Well I didn’t do too much today, un clamped everything and did some squareness checks. Side 1 Side 2 Side 3 there is about 3mm of out of square, I can only assume this is so because I have extended the fence out to its max. and opposite I needed to remove the out of square and did so by a off cut of wood as a shim taped to the edge and then carefully resawing both sides This corrected it as much as I was game to do. Another final sq...

Read this entry »


Part 4: The end

11-28-2020 05:00 AM by robscastle | 27 comments »

OK lets put this puppy to bed. Mainly sanding and sealing work What the top side looks like sealed and prior to 40g sanding What the under side looks like, ( and I am not sanding that) What the half lap miters look like First sand at 60g Second seal Out with the old In with the new That’s all Folks! However I am thinking of making a tool shelf below the top,... we will see what develops but for now its done. Not really a proje...

Read this entry »



DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com