LumberJocks

All Replies on Some assembly required...

  • Advertise with us
View Ripper70's profile

Some assembly required...

by Ripper70
posted 08-21-2017 08:19 PM


4 replies so far

View Jim Jakosh's profile

Jim Jakosh

22676 posts in 3495 days


#1 posted 08-22-2017 12:11 AM

What I do sometimes when I think I may not get it all glued in time is to glue half of it with the glue in place but put the other piece to it and do the clamping until the half is dried. Then I take apart the unglued pieces, coat them with glue, and do the clamping all over again. You have to have a piece that will come apart on the unglued side to do that. If it is all dadoed and captured, you just have to coat it and work real quickly.

Titebond III is all I ever use any more, too.

cheers, Jim

-- Jim Jakosh.....Practical Wood Products...........Learn something new every day!! Variety is the Spice of Life!!

View Rich's profile (online now)

Rich

4484 posts in 979 days


#2 posted 08-22-2017 12:34 AM

Similar to Jim’s method, I would glue it up in stages, using right-angle braces to ensure that the pieces are square. From what I gather from the photos and your description, you could easily glue the two partitions into the dadoes in the bottom, using the right-angle braces and clamps. When that’s dried, glue the top onto the partitions, let that dry and attach the sides with your long clamps. As long as your first glue up of the partitions to the bottom are square, unless you torque something in the later steps, the whole unit will be square, although continuing to use braces would be good just to play it safe.

The braces could be commercial, which are pricey, or you can make your own like this out of a double stack of 3/4 plywood. Just make sure the two sides are at a right angle and knock off the corner so they stay flush. I keep several sizes around for different sorts of projects.

-- Knowledge is not skill. Knowledge plus ten thousand times is skill. -- Shinichi Suzuki

View 000's profile

000

2859 posts in 1288 days


#3 posted 08-22-2017 01:30 AM

I would place your long clamps over the joints.
Where you have them will bow the sides and ultimately pull the joint crooked.
Keeping the clamps squared over the joint will help square the cabinet.

I would start with your 2 center dividers then attach your sides.
You will have plenty of time, don’t rush.

View Ripper70's profile

Ripper70

1275 posts in 1298 days


#4 posted 08-22-2017 02:31 PM

Thank you, gentlemen. For some reason, the simplest answers are the ones that are the most difficult for me to see. I will take your advice and proceed accordingly.

-- "You know, I'm such a great driver, it's incomprehensible that they took my license away." --Vince Ricardo

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com