All Replies on Need blade for Jointer

  • Advertise with us
View Srini's profile

Need blade for Jointer

by Srini
posted 08-17-2017 02:51 AM

4 replies so far

View MrUnix's profile (online now)


8211 posts in 3047 days

#1 posted 08-17-2017 02:54 AM

Any of the 6” knife sets should be fine… such as the Freud C350 set. Would probably be cheaper to have your existing ones sharpened though… unless they have been sharpened so much they are just too short.


-- Brad in FL - In Dog I trust... everything else is questionable

View DBDurf's profile


2 posts in 572 days

#2 posted 02-27-2019 12:52 AM

Hey Srini,

Any luck finding blades for you jointer? I ask because I was just given that same jointer by a friend.

View gtrgeo's profile


134 posts in 1278 days

#3 posted 02-27-2019 01:10 AM

I bought a set of these for my Jet about a year ago and have been pleased.

If you measure your knives you should be able to locate some that are similar but may be identified for a different make. These tools are not that much different at they were all coming from a few Asian manufacturers.

As far as cost vs sharpening, At the time it was ~$6 less for me to buy these over sharpening. They have gone up about that much in a year’s time. Plus you can have an extra set on hand if you get your old ones sharpened.


View DBDurf's profile


2 posts in 572 days

#4 posted 03-01-2019 03:44 PM

Thanks George.

I am very interested to see how much of a copy this jointer is of the Old Jet 6”. Externally it looks almost exactly the same. I am really hoping that the cutter head is the same because then I could get the Shelix cutter head that is made for the Jet once I finish restoring my jointer.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics