All Replies on Breadboard screw up

  • Advertise with us
View Shirk99's profile

Breadboard screw up

by Shirk99
posted 08-13-2017 10:06 PM

2 replies so far

View SuperCubber's profile


1138 posts in 3132 days

#1 posted 08-14-2017 01:59 AM

Not sure this is the best solution, but it could work:

Drill out the elongated holes on the sides through the top layer of the bread board and the tenon. Glue a short dowel to the bottom layer of the bread board only, then drill a larger, round hole on top and “plug” it with a larger dowel.

Hope that makes sense!

-- Joe | Spartanburg, SC | "To give anything less than your best is to sacrafice the gift." - Steve Prefontaine

View Shirk99's profile


3 posts in 1134 days

#2 posted 08-14-2017 06:08 AM

Thanks I think I will try that. I started the process…I drilled the elongated holes on the underside and put small dowels through the top. Wasn’t real sure the best way to plug them but I like your idea.
Thanks again

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics