All Replies on Millers Falls No 77 Router Plane

  • Advertise with us
View Bompa's profile

Millers Falls No 77 Router Plane

by Bompa
posted 08-05-2017 10:22 PM

3 replies so far

View Tim's profile


3859 posts in 2572 days

#1 posted 08-06-2017 12:20 AM

The pits and scratches on the sole won’t affect anything, but you’ll want to get the rust off so it doesn’t get worse and it can get onto the piece you’re working on. The pits on the bits will affect how sharp you can get them if they are right up at the cutting edge either on the bottom or on the bevel. If not they don’t matter much. I haven’t seen a 77 but I assume the bottom of the bits has a relief angle where only the cutting edge is touching the workpiece doing use. The rest of the bottom doesn’t affect the sharpness.

View Carloz's profile


1147 posts in 1202 days

#2 posted 08-06-2017 12:25 AM

If you want to post a photo here how nicely you removed scratches go ahead and do it. Otherwise if you plan to actualy use the plane why bother? You will get new scratches with use anyway. Same for the blades. If the pits are close to the cutting edge you’d better regrind the bevel. If not just let them be, eventually you will get rid of them as you keep honing the blade.

View Bompa's profile


6 posts in 1052 days

#3 posted 08-06-2017 12:28 AM

Thanks Tim.
The bottom of the bits do have a relief angle. When I get the bits cleaned up and all pits removed what surface do I sharpen? The bottom or the bevels on the bits?

-- Growing Old is Mandatory, Growing Up is Optional!

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics