LumberJocks

All Replies on Grizzly G1023 1993 Arbor Question

  • Advertise with us
View TD1212's profile

Grizzly G1023 1993 Arbor Question

by TD1212
posted 08-05-2017 03:19 PM


5 replies so far

View MrUnix's profile (online now)

MrUnix

7387 posts in 2588 days


#1 posted 08-05-2017 07:03 PM

Measure with a calliper to verify it’s diameter. Probably just machined to a closer tolerance than your other machine, or could possibly have a burr or mushroomed bit on it. The O.D. of the threads should be identical to the shoulder.

Cheers,
Brad

-- Brad in FL - In Dog I trust... everything else is questionable

View unbob's profile

unbob

810 posts in 2292 days


#2 posted 08-05-2017 07:06 PM

I think I might see a bit of a burr that has formed there, I would take a small fine file and or a small sharpening stone and smooth that edge carefully.

View TD1212's profile

TD1212

3 posts in 684 days


#3 posted 08-06-2017 06:15 PM

No Burr might just be a piece of dust but out side diameter measure 15.8 mm and inside on hole of blade measures 15.8 mm. With that said, you would need a press to get it on there. Have tried 2 different brand blades a Diablo and a Bosch with same result I assume the Makita blade that originally came with my slide miter may just be worn and is very tight but can be put on with a little pressure around hole. My thought is to run some polishing sand paper maybe 800 up to a 1500 grit on the arbor and see if I can pull off a fraction. also figure I will have to have machine running to get whatever comes off even all the way around.

Thoughts?

View MrUnix's profile (online now)

MrUnix

7387 posts in 2588 days


#4 posted 08-06-2017 06:20 PM

Not specific to your problem, but something similar to what Matthias did to true up the arbor would work… here is the page over at woodgears:

Fixing the wobble in a table saw arbor

I’d probably use a small flat file and just give it a touchup while spinning.

Cheers,
Brad

-- Brad in FL - In Dog I trust... everything else is questionable

View TD1212's profile

TD1212

3 posts in 684 days


#5 posted 08-06-2017 10:10 PM

FYI Took about 5 rounds of a light pressure with fine flat pin file, but got it to were I can push the blade on with a little pressure. Figured better to have it a little tight than go to far. Probably get a little wax and put on to keep rust away and keep it from freezing on but thanks for the wall to bounce off of. Always good to hear someone else say what you might be thinking. Almost like it had a little cone up to the Arbor flange maybe.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com