LumberJocks

All Replies on how to removecherry burl

  • Advertise with us
View Karda's profile

how to removecherry burl

by Karda
posted 08-02-2017 10:55 PM


7 replies so far

View TungOil's profile

TungOil

1328 posts in 1000 days


#1 posted 08-03-2017 12:56 AM

you can control the checking by painting the cut ends ASAP. Many folks use latex paint for this. In the past I used a special wax emulsion called Anchorseal that worked very well also. The burl might be ov use to someone that turns.

-- The optimist says "the glass is half full". The pessimist says "the glass is half empty". The engineer says "the glass is twice as big as it needs to be"

View Karda's profile

Karda

1691 posts in 1059 days


#2 posted 08-03-2017 02:37 AM

yes but how do I remove it without damaging the burls I know nothing about them. I would give it to any body who wants it I don’t turn things that small

View TungOil's profile

TungOil

1328 posts in 1000 days


#3 posted 08-03-2017 03:39 AM

I can’t help with the burl removal, hopefully someone with experience in this are will step in.

-- The optimist says "the glass is half full". The pessimist says "the glass is half empty". The engineer says "the glass is twice as big as it needs to be"

View Wildwood's profile

Wildwood

2736 posts in 2639 days


#4 posted 08-03-2017 10:36 AM

That’s not a burl just a knob on the tree for lack of better term.

-- Bill

View LeeMills's profile

LeeMills

678 posts in 1806 days


#5 posted 08-03-2017 01:39 PM

I would just take a slab off about 1” thick since most of this would be wasted anyway.
It may or may not be a bur. It may also be where a limb was pruned and it grew over it. Here is a quote from an online source that explains it.
”The wood around the wound begins to produce special compounds in the wood cells that set up a wall or barrier to isolate the infected area. This is called compartmentalization. In a vigorous tree, new growth continues to form and add to the sound wood. ”

-- We cannot solve our problems with the same thinking we used when we created them. Albert Einstein

View Nubsnstubs's profile

Nubsnstubs

1617 posts in 2235 days


#6 posted 08-03-2017 02:20 PM

Mike, if you have any tools for making hollow forms or vases, make your cut about 4” back from the bark. Figure out the diameter you want, and trim that on your band saw. Mount the end of the knob in your chuck as is. It looks big enough to get the jaws to clamp around it, but if they don’t, pressure from the tailstock should give you enough friction to allow turning. Turn a tenon, shape the outside up to the jaws, then reverse it. Clean up the area that the jaws contacted, drill out a hole appropriate to the neck size, clean it up some, and you could have a fairly nice looking vahhhzzze, weed pot or whatever you choose to call it. ............. Jerry (in Tucson)

-- Jerry (in Tucson) www.woodturnerstools.com

View Karda's profile

Karda

1691 posts in 1059 days


#7 posted 08-03-2017 06:07 PM

thank for the suggestions

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com