LumberJocks

All Replies on After tilting the table, I cannot tighten table bolt on Delta drill press

  • Advertise with us
View sotan's profile

After tilting the table, I cannot tighten table bolt on Delta drill press

by sotan
posted 08-02-2017 01:28 PM


1 reply so far

View mahdee's profile

mahdee

4291 posts in 2282 days


#1 posted 08-02-2017 02:09 PM

I don’t have one of these but from looking at the manual, it is possible that you loosen the bolt more than a 1/4” and it came off of what it get screwed in. If that is what happened, then I would try and put the index pin UU in first before tightening the bolt. The index pin might help adjust the position of the bolt to the thread it needs to connect with. A little bit of wiggling around and so on it should get you there.

-- earthartandfoods.com

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com