LumberJocks

All Replies on Flush trim cherry with router

  • Advertise with us
View BosnSki's profile

Flush trim cherry with router

by BosnSki
posted 07-24-2017 04:57 AM


3 replies so far

View jdh122's profile

jdh122

1102 posts in 3353 days


#1 posted 07-24-2017 09:56 AM

I’d do them one at a time. If you cut very close to the line (and assuming your bit is long enough, of course), you probably could do both at the same time. Or else in two passes by raising or lowering the bit (depending on where the bearing is on the bit). But I don’t really see much advantage to doing so. Using the template the two pieces should end up exactly the same even if done separately, and the time saving is so small that it hardly seems worth doing them together.

-- Jeremy, in the Acadian forests

View Gilley23's profile

Gilley23

489 posts in 918 days


#2 posted 07-24-2017 11:18 AM

Why risk the wear on your router and your bit? Just do them one at a time.

View Kazooman's profile

Kazooman

1373 posts in 2488 days


#3 posted 07-24-2017 11:26 AM

Do them one at a time and be certain to use a sharp bit. Cherry burns very easily. You do not want to have anything contributing to slowing the process down.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com