LumberJocks

All Replies on Sander Question

  • Advertise with us
View WoodjoeDrillson's profile

Sander Question

by WoodjoeDrillson
posted 02-24-2017 03:24 AM


3 replies so far

View HokieKen's profile (online now)

HokieKen

9207 posts in 1498 days


#1 posted 02-24-2017 01:45 PM

Depends very much on the type of cut. For straight edges or edges with slight convex curves, a belt or disk sander would be my preference. For concave surfaces or faces with tighter curves, a spindle sander would be the better solution.

-- Kenny, SW VA, Go Hokies!!!

View JBrow's profile

JBrow

1368 posts in 1279 days


#2 posted 02-24-2017 02:01 PM

WoodjoeDrillson,

I agree with HokieKen but do not have a spindle sander. I substitute a sanding drum chucked into the drill press. However, using a sander, rasp, file, or scraper is a slow go. A plane or similar tool like perhaps a spoke shave or curves, would be faster. A plane is easy enough to control, but some care would be required with the spoke shave.

If I need more than one workpiece that has non-straight edges, I like to build a template, using the sanding drum to smooth and fare the curves. I then use a pattern or flush trim bit in the router along with the template to remove mill marks left by the bandsaw or jig saw. If the edges are straight, a straight edge, preferably from wood or a wood-product sheet good, could be used as the router template.

View OSU55's profile

OSU55

2242 posts in 2349 days


#3 posted 02-24-2017 05:34 PM

Might consider a hand plane for straight surfaces, spokeshave for curves. May still need some sanding but much less

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com