LumberJocks

All Replies on Chair leg repair

  • Advertise with us
View AandCstyle's profile

Chair leg repair

by AandCstyle
posted 02-23-2017 03:16 PM


6 replies so far

View JCamp's profile

JCamp

953 posts in 880 days


#1 posted 02-23-2017 03:27 PM

I’m no expert but due to the lack of tools id suggest you repair it as is Using the correct glue and removing the screws and replacing with some dowels would likely work.
Your suggestion of cutting off just the top and replacing it seems to me like it would just move the weak point to a different location
Once again I am no expert, maybe some of the guys that are will chime in.. If no one does in a day or two you might post your question of the furniture makers forum

-- Whatsoever thy hand findeth to do, do it with all thy might

View Robert's profile

Robert

3343 posts in 1810 days


#2 posted 02-23-2017 03:41 PM

You’re probably right but I think epoxy is worth a try. Maybe a couple small pins.

-- Everything is a prototype thats why its one of a kind!!

View Alongiron's profile

Alongiron

653 posts in 3022 days


#3 posted 02-23-2017 03:43 PM

Art. My take is that the repair failed because all of the weight of the chair leg is on the piece that is broken because but that is where the inserts are for the bolts to attach. My idea would to remove the inserts and place them in the solid back piece. Glue the broken piece back on and sand smooth and finish. Purchase a couple of longer bolts to reattach the leg to the chair. THe weight should now bare on the solid piece of the leg.

-- Measure twice and cut once.....sneak up on it! Steve Lien

View Loren's profile

Loren

10477 posts in 3977 days


#4 posted 02-23-2017 04:17 PM

I would probably cut it off at an angle on
the band saw, plane the face flat, attach
a new block there and add little mouldings
if I felt like it to sort of match the look.

At this point it’s so messed up I wouldn’t
care about trying to make the repair parts
match perfectly.

View AandCstyle's profile

AandCstyle

3202 posts in 2586 days


#5 posted 02-23-2017 09:49 PM

Thanks for the responses so far. Right now I am leaning toward Steve’s suggestion as my solution.

-- Art

View AandCstyle's profile

AandCstyle

3202 posts in 2586 days


#6 posted 02-25-2017 12:11 AM

Here is the plan I have developed based on the above advice:

1. Cut off the jagged edge and fill the holes from the bolt inserts.
2. Make a patch to replace the cut off and the broken off piece and glue that in place.
3. Cut mortises through the corner block into the patch and make tightly fitting tenons.
4. Refinish the patch and adjoining surfaces as needed.
5. Glue the tenons in place and hope for the best. :)

Again, I appreciate the input.

-- Art

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com