LumberJocks

All Replies on MILLING

  • Advertise with us
View 52areaguard's profile

MILLING

by 52areaguard
posted 02-21-2017 06:05 PM


5 replies so far

View Monte Pittman's profile

Monte Pittman

30324 posts in 2701 days


#1 posted 02-21-2017 06:09 PM

Welcome to Lumberjocks.

Cutting thick slabs and properly stickering and stacking in a storage area would be better.

-- Nature created it, I just assemble it.

View sawdustdad's profile

sawdustdad

379 posts in 1248 days


#2 posted 02-21-2017 06:14 PM

Cut the lumber while green. Sticker and dry the boards. If you leave the logs whole you will induce checks (cracks) from differential drying that will run throughout the logs, making much of the wood useless (or less useful).

-- Murphy's Carpentry Corollary #3: Half of all boards cut to a specific length will be too short.

View Robert's profile

Robert

3371 posts in 1843 days


#3 posted 02-21-2017 06:59 PM

Yes, wait till you get back then cut and mill while green.

Depending on wood species, leaving them around can also result in insect damage.

-- Everything is a prototype thats why its one of a kind!!

View HerbC's profile

HerbC

1801 posts in 3222 days


#4 posted 02-21-2017 07:41 PM

Unless the trees are dying off now you would gain five years of growth if you don’t cut them now. Once they are cut you will get the best results by milling quickly into lumber and then properly air drying them followed by kiln drying if necessary and appropriate for the type of lumber and intended use.

Good Luck!

Thank you for your service.

Be Careful!

Herb

-- Herb, Florida - Here's why I close most messages with "Be Careful!" http://lumberjocks.com/HerbC/blog/17090

View tomsteve's profile

tomsteve

936 posts in 1582 days


#5 posted 02-21-2017 08:00 PM

welcome to the forum!! there are quite a few risks/consequences to letting logs sit for years on end before milling. maple is one that it doesn’t take long to start deteriorating. in fact, its possible to have a log that could be perfectly white if milled ASAP, but just sitting a few weeks will give it streaks.

imo, its best to mill as soon after cutting as possible.

theforestryforum.com is a great place with lots of experience and information on milling. you may want to check em out.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com