All Replies on Just snatched up a saw for cheap. I hope.

  • Advertise with us
View Iflypropjobs's profile

Just snatched up a saw for cheap. I hope.

by Iflypropjobs
posted 02-20-2017 03:34 PM

4 replies so far

View Maximum's profile


22 posts in 1370 days

#1 posted 02-21-2017 12:47 AM

Pictures would help get you responses…

View diverlloyd's profile (online now)


4005 posts in 2744 days

#2 posted 02-21-2017 02:39 AM

I have that same model saw but have the beisimeyer fence I like it a lot. The vega looks to be almost the same minus it used round tube instead of square tube. It’s been a good saw I hope you like it. If it has the miter gauge with the aluminum piece on it check the aluminum for being flat. Mine was flat on one side and the other had a bump in the center causing pieces to rock and unsquare cuts.

View Iflypropjobs's profile


2 posts in 1348 days

#3 posted 02-26-2017 04:47 AM

A few pics of what i’ve got & the end after rust removal, wing leveling & waxing.

The blade insert is warped & cracked – any idea where I should look for new ones? I’m still looking at the VegaPro fence system for it. Seems to run fine & vibration free – not bad for $150.

View Steve Peterson's profile

Steve Peterson

419 posts in 3969 days

#4 posted 02-26-2017 06:57 AM

Good score on the saw. And welcome to lumberjocks.

The insert looks like a standard design. I made a half dozen from some scrap hardwood flooring. They are practically indestructible. Rough them to size on a bandsaw and sand them to a tight fit. Get some short allen head set screws to adjust the height. Also, glue a short tab underneath the front to keep it from lifting out. Raise the blade through it and you have a perfect zero clearance insert.

-- Steve

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics