LumberJocks

All Replies on offsetting a drill press table on a Sears 15"

  • Advertise with us
View HarleySoftailDeuce's profile

offsetting a drill press table on a Sears 15"

by HarleySoftailDeuce
posted 02-18-2017 12:26 AM


8 replies so far

View patron's profile

patron

13648 posts in 3730 days


#1 posted 02-18-2017 01:53 AM

don’t have one myself
but the ones i’ve seen
the notched rack stays with the table
and turns with it
sliding around the post
that should be like yours
it could just be stuck from some minor rust

-- david - only thru kindness can this world be whole . If we don't succeed we run the risk of failure. Dan Quayle

View HarleySoftailDeuce's profile

HarleySoftailDeuce

320 posts in 3808 days


#2 posted 02-18-2017 02:43 AM

Hello from Bristol, Rhode Island !!
Thanks for the tip. I found the original pamphlet and it’s not a Craftsman…but a Delta….boy am I getting old or what ?? I’ll spray the base with some WD 40…that should do it.

Keep makin’ sawdust!

Paul

-- Paul, Bristol,Rhode Island

View papadan's profile

papadan

3584 posts in 3757 days


#3 posted 02-18-2017 03:31 AM

With nothing to jam it, the rack will move around the column like David said.

View HarleySoftailDeuce's profile

HarleySoftailDeuce

320 posts in 3808 days


#4 posted 02-18-2017 10:14 PM

Thanks papadan….

I gently tapped the top & bottom; they did not budge. As stated earlier… a shot of WD 40 might just do the trick. I’m glad LJ members are always here for when we all need some help. Enjoy the rest of your weekend.

Paul

-- Paul, Bristol,Rhode Island

View Kent's profile

Kent

206 posts in 2185 days


#5 posted 02-18-2017 10:40 PM

To help your WD40 and your mallet, try applying force using the hand crank. Place a chunk of 2×4 under the table and then lower the table onto the 2×4, effectively trying to lift the drill press, but only a bit!) with the table while you tap the pinion rack sideways, first from one side at the top, then the other side at the bottom, then switch it up.

You can also jam the 2×4 between the table and the head of the machine.

After I rotate my table freely, I have a bit of space between the pinion rack and the post, but it has never affected function.

-- If I knew then what I know now, I'd have made a completely different set of mistakes.

View papadan's profile

papadan

3584 posts in 3757 days


#6 posted 02-18-2017 10:49 PM

I did remember that an old benchtop press I had, did have the pinion gear set into a groove to prevent the table from rotating around the column.

View HarleySoftailDeuce's profile

HarleySoftailDeuce

320 posts in 3808 days


#7 posted 02-18-2017 11:02 PM

Thanks Patron, papadan & Kent for your help….should work.

-- Paul, Bristol,Rhode Island

View jimintx's profile

jimintx

916 posts in 1973 days


#8 posted 02-18-2017 11:25 PM

.

-- Jim, Houston, TX

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com