All Replies on Talk me out of buying a new table saw

  • Advertise with us
View patcollins's profile

Talk me out of buying a new table saw

by patcollins
posted 02-18-2017 12:24 AM

3 replies so far

View Maximum's profile


22 posts in 1051 days

#1 posted 02-18-2017 12:38 AM

Don’t buy a new saw.

View isotope's profile


177 posts in 2192 days

#2 posted 02-18-2017 01:34 PM

OK, but just because you asked….
I think the fence on a table saw is the most important feature, and I’ve seen lots of people on this forum speak highly of the T3. So, you could buy the fence and install on your 113. If your still itching for a new saw, you could look for a used cabinet saw. Because lots of the older cabinet saws have crappy fences, they’re pretty cheap. But you won’t care because you have the T3.

View B4B's profile


163 posts in 1926 days

#3 posted 02-19-2017 04:51 AM

What would make your woodworking experience enjoyable? If you can already do everything you want to do on your C-man 113 then keep using it, put a new fence on it and make stuff.

I will say that I did purchase an after-market fence for the craftsman saw, I think I paid 150+tax for a Shop Fox W1411 w/rails from Grizzly (clearance/close-out deal). They still sell the fence, but w/o the rails. At the time, that was stretching my budget. I now don’t worry about fence alignment when locking it in place, using the saw is more enjoyable.

As for the motor hanging out the back, replace the two bolts that secure the motor to the housing with bolts that you can tighten with your thumbs and take the motor off when not in use, I do this and it adds ~1 minute to the setup and breakdown of the saw. I have a small area at the back of my car port and if I don’t take the motor and fence off, I can’t fit it into the storage area.

If you still don’t like the motor hanging off the back, put the original fence back on and sell it, look for another saw.

If looking for new, take a look at Grizzly, they have excellent customer service and their equipment is generally well reviewed and considered good bang for your buck or keep an eye on craigslist for old iron. In my area I’ve seen old iron go anywhere from a couple hundred and up depending on the condition and the seller’s motivation to offload the equipment. Sometimes all they need is a little TLC and they can be great work-horses.

-- There's two routers in my vocab, one that moves data and one that removes wood, the latter being more relevant on this forum.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics