All Replies on narrow table support design

  • Advertise with us
View Karda's profile

narrow table support design

by Karda
posted 02-11-2017 07:44 AM

8 replies so far

View CaptainSkully's profile


1612 posts in 4124 days

#1 posted 02-11-2017 05:57 PM

If your aprons are 2×4’s are on edge, you shouldn’t need any additional support for that size/weight.

-- You can't control the wind, but you can trim your sails

View William Shelley's profile

William Shelley

609 posts in 2035 days

#2 posted 02-11-2017 06:00 PM

If you’re asking about the legs, I would say make them splayed out a bit like a sawhorse because otherwise the whole thing might be a bit tippy.

-- Woodworking from an engineer's perspective

View Karda's profile


1843 posts in 1119 days

#3 posted 02-11-2017 07:26 PM

ok thanks

View ArtMann's profile


1447 posts in 1382 days

#4 posted 02-12-2017 02:07 AM

I don’t think your table will be stable unless you tie it to a wall. It is just too narrow. You can either put legs on it and shove it against the wall or actually mount the table to the wall without any legs if the situation allows it.

View Karda's profile


1843 posts in 1119 days

#5 posted 02-12-2017 02:44 AM

I was wondering if I could use the wall, it is block with a block beam support creating a corner. how would you tie into a block wall

View Mike_D_S's profile


598 posts in 2780 days

#6 posted 02-12-2017 09:11 PM

A picture would help, but if it’s masonry block, using Tapcon screws to attache some mounting blocks to the wall should let you tie the table to the wall fairly simply.

Also, I wouldn’t go without legs. During normal use a lathe will have vibrations and you don’t want to end up with some kind of failure later where the whole assembly falls of the wall.

Tied to the wall, you shouldn’t have to splay the legs. Also, you can enclose the legs as storage at some point in the future.


-- No honey, that's not new, I've had that forever......

View mrbob's profile


182 posts in 1135 days

#7 posted 02-12-2017 09:46 PM

Legs with feet like this, you can extend the feet, make them longer then the bench is wide, for added stability.

View Karda's profile


1843 posts in 1119 days

#8 posted 02-12-2017 10:04 PM

thanks that gives me a lot to think about, I could use feet up to 2 feet long. I like the design of the work bench you posted that is an idea. here is a picture of where I want to ut it.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics