All Replies on Door threshold glue-up -- Am I making a big mistake?

  • Advertise with us
View William Shelley's profile

Door threshold glue-up -- Am I making a big mistake?

by William Shelley
posted 01-31-2017 05:06 PM

6 replies so far

View Madmark2's profile


1729 posts in 1476 days

#1 posted 01-31-2017 05:11 PM

Use a marble threshold . . .


-- The hump with the stump and the pump!

View Ted78's profile


415 posts in 2888 days

#2 posted 01-31-2017 05:28 PM

I have no real experience here so take this with a grain of salt, but my instinct is that is will be fine. Wood moves but I don’t think ipe over the width of a threshold is going to move enough to cause problems even in that environment. I suspect there is enough give in the floor the threshold is screwed down to alleviate any problems. If your worried about it you could drill the holes in the ipe just a bit oversized.

-- Ted

View LittleShaver's profile


696 posts in 1507 days

#3 posted 01-31-2017 06:42 PM

Should be fine. Wood expands and contracts across the width. You’ve pinned it down the center so is has room to push towards the sides. And while it haven’t looked it up, something that narrow is not going to change much.

-- Sawdust Maker

View TungOil's profile


1383 posts in 1383 days

#4 posted 01-31-2017 07:00 PM

are you tiling up against one side? If so you might have trouble with the grout lines, they are unforgiving to any wood movement

-- The optimist says "the glass is half full". The pessimist says "the glass is half empty". The engineer says "the glass is twice as big as it needs to be"

View William Shelley's profile

William Shelley

609 posts in 2357 days

#5 posted 01-31-2017 07:46 PM

Thanks everyone.

are you tiling up against one side? If so you might have trouble with the grout lines, they are unforgiving to any wood movement

- TungOil

It’s almost touching existing tile in a couple places but there’s about 1/8-3/16” gap that will be filled with high performance silicone caulking which should absorb any movement.

-- Woodworking from an engineer's perspective

View Mike_D_S's profile


605 posts in 3102 days

#6 posted 02-05-2017 04:21 PM

Generally,I agree that the little bit of movement you may get is probably not going to be an issue.

But I’ll take a very practical approach, you’ve already drilled and countersunk the screws, so basically you’re already locked in on the mounting method. If it cracks or warps, so be it. Either the movement will be so small you won’t care or you’ll have to basically remake the threshold. So just go with it and see what happens.

But if you were going to remake it and assuming that it doesn’t stick up too much so that people are constantly kicking it with a lot of force, then I would recommend using something like liquid nails construction adhesive to mount it next time instead of screws. A generous bead down the middle and then silicone calk in the gaps on the side. Since it’s essentially only fixed in the middle, expansion will not be an issue as the caulk will absorb whatever movement you have. Also gives a clean solid wood look from the top.


-- No honey, that's not new, I've had that forever......

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics