LumberJocks

All Replies on Delta 36-725 steel wing help

  • Advertise with us
View EBreindel's profile

Delta 36-725 steel wing help

by EBreindel
posted 01-29-2017 08:20 PM


9 replies so far

View MrUnix's profile

MrUnix

7388 posts in 2594 days


#1 posted 01-29-2017 08:33 PM

Define ‘sags’, and have you attached the wings to the fence rails (which helps support them). And I don’t see why you would be worried about stripping the screws – unless you are really torquing them down for some unknown reason.

Cheers,
Brad

-- Brad in FL - In Dog I trust... everything else is questionable

View WhyMe's profile

WhyMe

1153 posts in 1956 days


#2 posted 01-29-2017 09:05 PM

Can’t visualize what’s going on, but the side wings are installed but not tightened fully to the cast iron top Then the rails should be installed and leveled to the cast iron top and fully tightened. Then the wings are bolted to the rails but just snug and then adjusted (I used a rubber mallet to tap) flush and level to the cast iron top. Once wings are level and flush to the cast iron top then tighten all wing bolts.

View Woodknack's profile

Woodknack

12817 posts in 2775 days


#3 posted 01-30-2017 03:41 AM

Shims are often required for making wings level.

-- Rick M, http://thewoodknack.blogspot.com/

View Tideline77's profile

Tideline77

102 posts in 1167 days


#4 posted 01-30-2017 08:29 AM

Search function
There are several threads on this forum covering this issue and also on youtube

View knotscott's profile

knotscott

8290 posts in 3771 days


#5 posted 01-30-2017 10:26 AM

Make sure the cast iron mating surface doesn’t have burrs or debris preventing good contact. Get it close, then use some persuasion with a rubber mallet, shim as needed, before tightening the bolts fully.

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

View EBreindel's profile

EBreindel

10 posts in 931 days


#6 posted 01-30-2017 10:39 AM

Thank you. I will try the shims and report back.

View OSB's profile

OSB

147 posts in 921 days


#7 posted 01-31-2017 05:20 PM

Get a good 3-4” machinist square and some feeler gauges, then measure your table and wing edges for square.

If something is really off, see about an exchange, otherwise you can use the feeler gauge to determine how much shim you need.

View liamtoh1's profile

liamtoh1

59 posts in 896 days


#8 posted 02-08-2017 06:35 AM

Have you seen this YouTube video?

View simoncpj's profile

simoncpj

23 posts in 907 days


#9 posted 02-12-2017 04:47 AM

I just set one up. Get the bolts to the cast iron table top finger tight. Plus a bit, then get the bolts on the rails finger tight plus and adjust for level. Tighten down the ones furthest away first then use a block and mallet to tap the edge against the cast iron top to level.

If that doesn’t work, flip the wing around and try the other side. Or make a router table out of plywood on that side.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com