All Replies on Sassafras and oak headboard?

  • Advertise with us
View alittleoff's profile

Sassafras and oak headboard?

by alittleoff
posted 01-29-2017 01:06 AM

3 replies so far

View JBrow's profile


1368 posts in 1731 days

#1 posted 01-29-2017 06:33 PM


Even though the sassafras lumber may look flat and straight, it may have a slight cup, bow, or twist. In an abundance of caution, my approach would be to mill one face flat, and then run the sassafras through the planer along with the rest of the project lumber to the same thickness. Doing so would help the project come together with fewer problems by ensuring straight and flat lumber.

There is no workshop information posted with your profile, so I assume you use a jointer to flatten your lumber and that your jointer width is 6” or 8”. Therefore, ripping the sassafras narrow enough so that it could be milled flat on the jointer seems to me to be the good approach.

If you are a hand plane woodworker, I see no reason why the wide boards could not be used without ripping. I fail to see any particular advantage in ripping a wide board in half and then re-gluing back together. I remain largely unconvinced that alternating growth rings during a glue-up offers any benefit if the wood is handled and finished properly. But bear in mind, I have not built projects using wide format lumber. I use narrower (6” – 8” as the widest) boards due to availability and cost.

My comments presuppose the all the project lumber is dry, acclimated to the shop, and stickered after milling. I also assume that all exposed surfaces and edges will be planed, sanded, and finished the same.

View Fred Hargis's profile

Fred Hargis

6329 posts in 3304 days

#2 posted 01-29-2017 09:27 PM

It’s a question that seems to have proponents on both sides, so it kind of flip a coin. If I fear warping/twisting, I have no problem ripping a board down and re-gluing it. It’s always worked for me, but whether I had to do it is anyone’s guess. I’m not done a few times, and also not had problems. Part of what might persuade me one way it the other is the oversize in the finished project….smaller (to me) seems to have less chance of problems, and I might not rip. Whatever your choice is, I’m fairly certain that roughly 1/2 of us would agree with you.

-- Our village hasn't lost it's idiot, he was elected to congress.

View alittleoff's profile


548 posts in 2088 days

#3 posted 01-29-2017 11:58 PM

I have a 12 in. Planer and only a 6in. Joiner, looking for an 8 but haven’t found one yet. This lumber came from a lumber co. That shut down. I bought quite a bit of black walnut, oak and the sassafras all were wide boards. The boards looked so good or the grain did I just hated to rip them if I didn’t have to.
Thanks for the answers, well see what happens.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics