LumberJocks

All Replies on Bandsaw alignment

  • Advertise with us
View unclearthur's profile

Bandsaw alignment

by unclearthur
posted 01-27-2017 07:51 AM


5 replies so far

View Danpaddles's profile

Danpaddles

573 posts in 2708 days


#1 posted 01-27-2017 08:58 AM

I can’t speak to the angle thing, I’ll check mine tomorrow. As to how thick you can rip- with the right blade, the height of the guide is your limit. You may need to feed slower then someone with a big honking saw, but you can slice whatever will fit. I’ve run 11 inch wide red oak, although I had some trouble keeping everything lined up, the saw just keeps chugging along.

I am not a fan of the steel blade guides, yours look to be original equipment. I like using micarta blocks. I suspect I’d REALLY like the carter guides, but I am too cheap to pop for those.

-- Dan V. in Indy

View Fred Hargis's profile

Fred Hargis

5552 posts in 2889 days


#2 posted 01-27-2017 12:23 PM

I probably wouldn’t worry about that, but I think you can shim under the front trunnions to get the front of the table higher.

-- Our village hasn't lost it's idiot, he was elected to congress.

View dhazelton's profile

dhazelton

2837 posts in 2692 days


#3 posted 01-27-2017 01:22 PM

Open the wheel covers and take a yardstick or straightedge and put it against the two wheels – are the parallel to each other? If the top wheel is set very far back from the bottom one maybe you bent the riser. If that’s okay then just undo the bolts in front and put a washer or two as suggested above. If you can’t do that and the blade tracks fine and the machine cuts without binding you’re probably okay.

View unclearthur's profile

unclearthur

256 posts in 2183 days


#4 posted 02-13-2017 04:33 AM

I ended up placing a few washers under the rear trunnions as suggested and it squared up no problem. Thanks for the advice!

View Robert's profile

Robert

3405 posts in 1876 days


#5 posted 02-13-2017 01:13 PM

What Fred and the last poster said.

I had to do that on my little machine.

-- Everything is a prototype thats why its one of a kind!!

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com