LumberJocks

All Replies on Outdoor Project

  • Advertise with us
View myxology's profile

Outdoor Project

by myxology
posted 09-14-2016 05:14 PM


7 replies so far

View ScottM's profile

ScottM

711 posts in 2442 days


#1 posted 09-14-2016 05:29 PM

Well, you’ve got redwood, teak, cypress, white oak, sapele, mahogany, and even pressure treated. Never used redwood so I’m not sure of your hesitation, but if that’s available in your area and reasonable in price try it out. We try and succeed but many times we try and learn….

View Aj2's profile

Aj2

2050 posts in 2093 days


#2 posted 09-14-2016 05:29 PM

WRC western red cedar.Thats what I would use.
The redwood I see down here in So Cal is very poor lots of sap wood.
If you can find redwood that’s mostly heart that’s good.
Unless your going to paint it don’t use DF.

Aj

-- Aj

View CharlesNeil's profile

CharlesNeil

2475 posts in 4166 days


#3 posted 09-14-2016 06:14 PM

no matter what you “seal it with”, be careful, exterior finishes are an issue, i have a video coming out next week, about it . Will post it here

View HokieKen's profile

HokieKen

8556 posts in 1434 days


#4 posted 09-14-2016 06:24 PM

Cedar or White Oak would be my call over here on the East Coast.

-- Kenny, SW VA, Go Hokies!!!

View gargey's profile

gargey

1013 posts in 1071 days


#5 posted 09-14-2016 06:39 PM

Most any wood can cup if not seasoned, jointed, joined and assembled correctly. Did you do it right? Selecting straight boards is obviously a must.

View myxology's profile

myxology

73 posts in 1536 days


#6 posted 09-15-2016 01:26 PM

Ok, so I’ve selected Western Red Cedar. They have it at my local store. I can’t afford the really pretty stuff, but the one I can afford does have some nice straight boards and it’s all kiln dried so hopefully they won’t change too much more. I intend to buy them this weekend and let them season in my shop for at least a week before I work with them. I’m hoping that’s enough time.

As for how I’m going to joint and join them… I intend to joint two short sides and one wide side on my jointer and then run them through the thickness planer to get them all to the same size. Thankfully I have an 8” jointer! Then I was going to biscuit and glue it together. Even though I’ve never done it, I intend to do breadboard ends.

I’m curious though… I’ve seen some people use a router and put a V groove along the long joints in the table top. Would you do that? I hadn’t really planned on it.

-- Is this thing plugged in?

View McFly's profile

McFly

273 posts in 1322 days


#7 posted 09-15-2016 08:00 PM

V groove would just be a crumb catcher.
If you’re dead set on it, put a chamfer on the boards before you glue them up with a table router.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com