All Replies on SawStop Router Table

  • Advertise with us
View jay443's profile

SawStop Router Table

by jay443
posted 09-09-2016 01:08 PM

2 replies so far

View Fred Hargis's profile

Fred Hargis

6315 posts in 3298 days

#1 posted 09-09-2016 08:42 PM

I did that some years ago with a Delta extension. The bracing I used was 3/4” angle iron, and used several pieces. It stayed flat for several years, then I sold that saw.The Sawstop table is 1/2 of a torsion box (at least mine is). I would bet all 3.76 of this months SS check that if you put a skin on the bottom of their table, it would be a complete torsion box, and may not need any other bracing.

-- Our village hasn't lost it's idiot, he was elected to congress.

View clin's profile


1114 posts in 1801 days

#2 posted 09-10-2016 02:17 AM

I have a 36” SawStop PCS and have intentions of mounting a router to the extension table. I expect I’ll add bracing and that should be all it needs, and skinning the bottom as Fred suggests is a great idea to add yet more strength. There’s minimal bracing on it now, so it will need more than just an added skin. But all of that would be trivial do do.

For bracing I’ll use Baltic Birch plywood since it will be relatively stable. Though if made into an actual torsion box, even MDF would work fine.

It also would be trivial to build a completely new extension table (this saving the stock extension if desired). And again, I like Fred’s torsion box idea. If you make one from scratch, you could laminate the top and for stability the bottom as well. Though given it’s size, two layers of particle board, with plastic laminate would be plenty stiff as well and not that much heavier.

-- Clin

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics