All Replies on Mounting workbench casters to supports - help?

  • Advertise with us
View rhybeka's profile

Mounting workbench casters to supports - help?

by rhybeka
posted 09-05-2016 05:27 PM

3 replies so far

View tyvekboy's profile


2033 posts in 3822 days

#1 posted 09-05-2016 07:04 PM

My suggestion would be to add some material to the skirt so that it would fill the recess.

Then you could add a plywood plate attached too both the cabinet side and the filler. That would give you a good surface to attach the wheels.

The plate might not be necessary if the screws have a good place to be screwed into.

Then you could attach the workbench wheels to the plywood.

Hope that helps.

-- Tyvekboy -- Marietta, GA ………….. one can never be too organized

View Mark Wilson's profile

Mark Wilson

2841 posts in 1872 days

#2 posted 09-05-2016 07:53 PM

When I assembled my store-bought workbench, it wasn’t tall enough. I simply enough pieces of scrap wood to the base with screws to make it taller.

-- Mark

View rhybeka's profile


4870 posts in 3930 days

#3 posted 09-05-2016 08:37 PM

Thanks guys :) I thought on it a bit more and combined your suggestions :D cut a ledge out of the 4×4 to fit the skirt and add 2 in to the bottom. Only have one done though since I hand sawed it!

-- Beka/Becky - aspiring jill of all trades, still learning to not read the directions.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics