LumberJocks

All Replies on Disston Saw Handle Repair?

  • Advertise with us
View MaurerPower's profile

Disston Saw Handle Repair?

by MaurerPower
posted 08-31-2016 06:05 AM


5 replies so far

View BigYin's profile

BigYin

421 posts in 2983 days


#1 posted 08-31-2016 06:23 AM

View HokieKen's profile

HokieKen

11635 posts in 1705 days


#2 posted 08-31-2016 06:15 PM

Looks salvagable to me. Fill cracks as best you can with some glue or epoxy. Reshape the horns with rasp/sandpaper. Then soak her good with some BLO. That’s what I’d do anyway :-)

-- Kenny, SW VA, Go Hokies!!!

View Don W's profile

Don W

19387 posts in 3134 days


#3 posted 08-31-2016 09:59 PM

Not even close to firewood. I’d do about the same a Kenny, a coat of wax and post the before and after on the Restoration before and after thread!!

-- http://timetestedtools.net - Collecting is an investment in the past, and the future.

View coopersdad's profile

coopersdad

33 posts in 1407 days


#4 posted 09-01-2016 02:17 AM

I just re-did a Disston like that. I didn’t have the cracks, but as the other guys said, some dark epoxy should work well. The upper horn on mine was about like your lower. I used another handle for a bit of wood, glued and clamped with rubber bands, some blo darkened it up and it matches the original wood quite well. I had to replace a couple of improper nuts too. Bringing these old saws back to life is very satisfying. Go for it and have fun!

View MaurerPower's profile

MaurerPower

21 posts in 1216 days


#5 posted 09-01-2016 03:11 AM

Thanks for the reassurance that it is salvageable. If the repair turns out nicely I’ll definitely update the threat with some after pictures. It’ll never be too beautiful though because the saw plate has a lot of pitting, but since it is 5 ppi I think it’ll be okay.

As far as filling in the cracks with epoxy, is there a particular epoxy I should be using or will any epoxy do the job? I have some gorilla brand 15 minute epoxy in my glue drawer that I think might work. Should I perhaps coat the area surrounding the cracks with a light coat of shellac to keep the epoxy from soaking into the surrounding areas and preventing BLO from soaking in after I sand the handle smooth?

Coopersdad, that is a very good idea harvesting some wood off of a different handle to remake the horns. I also like how you traced the outline of the handle of cardboard. That looks like it would help a lot for trying to make a new horn.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com