All Replies on Adirondack chair finish question

  • Advertise with us
View AmericanPatriot's profile

Adirondack chair finish question

by AmericanPatriot
posted 08-23-2016 03:01 PM

2 replies so far

View JBrow's profile


1368 posts in 1725 days

#1 posted 08-30-2016 01:26 AM


My approach is to apply finish to all exposed wood, whether an indoor or outdoor project. In those areas of the chair where applying finish after assembly would be difficult or impossible, I would therefore apply finish before assembly since pre-assembly may be the only opportunity to ever protect those difficult areas.

While it sounds as if the finish you will use offers UV protection, moisture protection is, in my opinion, also important. Pre-finishing hard-to-get-at areas will also provide moisture protection.

Even though you probably already know, I’ll mention that areas where glue will be applied should get no finish. But on joints held only by screws, all wood making up the joint would get some finish. This is because water can penetrate the joint and enter the wood.

View nightguy's profile


213 posts in 1467 days

#2 posted 08-30-2016 04:28 AM

I agree with JBrow, I looked up your finish you want to use and it sounds like when needed to be redone, a clean up, some light sanding. I used Australian Timber Oil on my white oak adirondack stuff, I still got some mold after a year outside through a WI winter. WHAT you do not what to use is a film finish, it will not hold up and a real PITA to redo. I think there is no perfect exterior finish in any climate other then the SW if it is outside all year.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics