All Replies on Delta Jointer Blades

  • Advertise with us
View Kazooman's profile

Delta Jointer Blades

by Kazooman
posted 08-15-2016 10:39 PM

5 replies so far

View WhyMe's profile


1196 posts in 2128 days

#1 posted 08-15-2016 10:46 PM

I’ve gotten HSS jointer knives from American National Knife before and they seem decent. I have no complaints.

View pintodeluxe's profile


6017 posts in 3381 days

#2 posted 08-15-2016 10:52 PM

Just replace them. Sharpening cost just as much as replacement knives. I usually buy from Holbren or Global, and they both offer 8” jointer knives for around $20 (for a set of three knives). 6” are even cheaper.

-- Willie, Washington "If You Choose Not To Decide, You Still Have Made a Choice" - Rush

View knotscott's profile


8347 posts in 3943 days

#3 posted 08-16-2016 12:01 AM

Holbren, Infinity, Grizzly, Hartville Tool, Ebay, Amazon, Rockler, Woodcraft….all should have decent blades that will fit.

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

View MrUnix's profile


7533 posts in 2766 days

#4 posted 08-16-2016 12:07 AM

If the existing knives are sharp, you can just move one or two over slightly to get rid of the ridges they are leaving behind. That will at least get you working while you look for replacement blades – which as others have stated, can be sourced from lots of different places/manufacturers.


-- Brad in FL - In Dog I trust... everything else is questionable

View Kazooman's profile


1388 posts in 2520 days

#5 posted 08-16-2016 10:43 AM

Thanks for the advice. It is good to know that most of these after market suppliers sell decent blades. Holbren was mentioned twice, so I will probably start there.

Thanks for the reminder about sliding a knife over. I have done that on my planet in the past with good results.

I just wish I had bought a dozen sets of Delta knives way back when they were cheap. I could sell them for a better return than playing the stock market.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics