LumberJocks

All Replies on Pergola type slatted roof with 1x4 slats : How to join them to frame?

  • Advertise with us
View mospamo's profile

Pergola type slatted roof with 1x4 slats : How to join them to frame?

by mospamo
posted 08-10-2016 08:10 PM


2 replies so far

View tmasondarnell's profile

tmasondarnell

106 posts in 2147 days


#1 posted 08-11-2016 07:04 PM

If understand you correctly, you want the top of slats to be flush with the top of the rafters. Correct?

Unless you are using rough cut lumber, the 1×4 slats will only be 3/4 inch thick. I would not recommend notching material this thin.

You need to notch out the rafters only to accommodate the slats. It will be much easier and stronger.

Also, given the ratio of your slats depth (1) to their width (4), I would be very careful about how far you overhang the slats from the rafters. Material that thin and wide will warp very easily outdoors.

View mospamo's profile

mospamo

6 posts in 1795 days


#2 posted 08-12-2016 03:40 AM

Tmasondarnell thanks for the very helpful reply.
You convinced me to just go the easy route and lay the 1×4’s down width wise on the rafters. Also, the overhang will only be a few inches.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com