LumberJocks

All Replies on Clamping system for new drill press table

  • Advertise with us
View DW833's profile

Clamping system for new drill press table

by DW833
posted 08-08-2016 04:05 AM


5 replies so far

View MadMark's profile

MadMark

979 posts in 1996 days


#1 posted 08-08-2016 04:53 AM

I use a stick with a 1/4-20 bolt & knob. It easily sets the edge to bit distance. If I need to cut multiples a small wood block and clamp is sufficient.

It also works as an anti-rotation stop.

M

-- Madmark - [email protected] Wiretreefarm.com

View Planeman40's profile

Planeman40

1457 posts in 3304 days


#2 posted 08-08-2016 12:36 PM

The very best all round drill press clamping devise I have ever found (and have) is this one. http://www.travers.com/cam-lock-drill-press-clamp/p/61-171-001/ and http://cdnll.travers.com/images/xl/61-171-001act.jpg It attached to the drill press column, slides up and down the column, and swings to clamp the work or out of the way. Always there and can instantly be swung into place. No bolting and un-bolting to the table. I have used this for the past 40 years and LOVE IT!

-- Always remember: It is a mathematical certainty that half the people in this country are below average in intelligence!

View Woodbum's profile

Woodbum

898 posts in 3609 days


#3 posted 08-08-2016 12:42 PM

I have T track and Woodpeckers hold downs and use them a lot . If you don’t use them, and don’t need them, leave the clamping system off and do it the way that you have been doing it. That’s my simple answer. Good luck, have fun and work safely.

-- "Now I'm just another old guy wearing funny clothes"

View teejk02's profile

teejk02

504 posts in 1668 days


#4 posted 08-08-2016 02:36 PM

I kept it simple and bolted an oversized piece of 3/4” mdf using the existing slots in the table and carriage bolts recessed to stay below the table surface. I nipped one corner at a 45 to keep access to the elevation crank. I opened the center with a 1” hole saw to make sure I don’t drill into the original table. When I want to clamp anything, I clamp to the edges of the auxiliary table with QuickClamps or c-clamps. I also made a short fence that clamps to that table.

View JBrow's profile

JBrow

1368 posts in 1463 days


#5 posted 08-09-2016 02:43 AM

DW833,

I installed a fence on my auxiliary drill press table. The fence rides in T-tracks and easily adjusts and locks in place. I rarely bore a hole without setting the fence. Since I can press and hold the work piece against the fence, I find hold down clamps are unnecessary and therefore I have none.

As an aside, the auxiliary table has a slide out center insert section with a large shallow hole bored on one end of the insert into which sanding drums can be recessed. The insert can be flipped around to provide solid backing for drilling. Since it slides in and out, a fresh backer surface can be exposed. The table is covered with ¼” thick hardboard and the insert is cover with its own piece of the hardboard so the hardboard on the insert can be replaced when it is chewed up.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com